CCNA2 v6.0 Practice Final Exam Answer 2017

CCNA2 v6.0 Practice Final Exam Answer 2017 CCNA2 v6.0 Practice Final The buffers for packet processing and the running configuration file are temporarily stored in which type of router memory? flash NVRAM RAM ROM What is the minimum configuration for a router interface that is participating in IPv6 routing? to have only a link-local IPv6 […]
Continue reading…

 

CCNA2 v6.0 Chapter 10 Exam Answers 2019

CCNA2 v6.0 Chapter 10 Exam Answers 2018 2019 A ping fails when performed from router R1 to directly connected router R2. The network administrator then proceeds to issue the show cdp neighbors command. Why would the network administrator issue this command if the ping failed between the two routers? The network administrator suspects a virus […]
Continue reading…

 

CCNA2 v6.0 Chapter 9 Exam Answers 2019

CCNA2 v6.0 Chapter 9 Exam Answers 2019 What is the primary purpose of NAT? conserve IPv4 addresses increase network security allow peer-to-peer file sharing enhance network performance Explanation: NAT was developed to conserve IPv4 addresses. A side benefit is that NAT adds a small level of security by hiding the internal network addressing scheme. However, […]
Continue reading…

 

CCNA2 v6.0 Chapter 8 Exam Answers 2019

CCNA2 v6.0 Chapter 8 Exam Answers 2018 2019 Which DHCPv4 message will a client send to accept an IPv4 address that is offered by a DHCP server? unicast DHCPACK broadcast DHCPACK unicast DHCPREQUEST broadcast DHCPREQUEST Explanation: When a DHCP client receives DHCPOFFER messages, it will send a broadcast DHCPREQUEST message for two purposes. First, it […]
Continue reading…

 

CCNA2 v6.0 Chapter 7 Exam Answers 2019

CCNA2 v6.0 Chapter 7 Exam Answers 2018 2019 In which configuration would an outbound ACL placement be preferred over an inbound ACL placement? when the ACL is applied to an outbound interface to filter packets coming from multiple inbound interfaces before the packets exit the interface when a router has more than one ACL when […]
Continue reading…

 

CCNA2 v6.0 Chapter 6 Exam Answers 2019

CCNA2 v6.0 Chapter 6 Exam Answers 2018 2019 What are three primary benefits of using VLANs? (Choose three.) security a reduction in the number of trunk links cost reduction end user satisfaction improved IT staff efficiency no required configuration Explanation: Security, cost reduction, and improved IT staff efficiency are all benefits of using VLANs, along […]
Continue reading…

 

CCNA2 v6.0 Chapter 5 Exam Answers 2019

CCNA2 v6.0 Chapter 5 Exam Answers 2018 2019 What is a function of the switch boot loader? to speed up the boot process to provide security for the vulnerable state when the switch is booting to control how much RAM is available to the switch during the boot process to provide an environment to operate […]
Continue reading…

 

CCNA2 v6.0 Chapter 4 Exam Answers 2019

CCNA2 v6.0 Chapter 4 Exam Answers 2019 A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.) lower bandwidth requirements reduced cost for […]
Continue reading…

 

CCNA2 v6.0 Chapter 3 Exam Answers 2019

CCNA2 v6.0 Chapter 3 Exam Answers 2018 2019 Which dynamic routing protocol was developed to interconnect different Internet service providers? BGP EIGRP OSPF RIP Explanation: BGP is a protocol developed to interconnect different levels of ISPs as well as ISPs and some of their larger private clients. Which routing protocol is limited to smaller network […]
Continue reading…

 

CCNA2 v6.0 Chapter 2 Exam Answers 2019

CCNA2 v6.0 Chapter 2 Exam Answers 2019 What are two advantages of static routing over dynamic routing? (Choose two.) Static routing is more secure because it does not advertise over the network. Static routing scales well with expanding networks. Static routing requires very little knowledge of the network for correct implementation. Static routing uses fewer […]
Continue reading…

 

CCNA2 v6.0 Chapter 1 Exam Answers 2019

CCNA2 v6.0 Chapter 1 Exam Answers 2018 2019 When a router receives a packet, what information must be examined in order for the packet to be forwarded to a remote destination? destination MAC address source IP address destination IP address source MAC address Explanation: When a router receives a packet, it examines the destination address […]
Continue reading…

 

CCNA2 v6.0 ​​Pretest Exam Answer 2019

CCNA 2 RSE 6.0 Pretest Exam Answers 2018 2019 100% Which two components are configured via software in order for a PC to participate in a network environment? (Choose two.) MAC address IP address kernel shell subnet mask What is the correct order for PDU encapsulation? To revert to a previous configuration, an administrator issues […]
Continue reading…