Refer to the exhibit. Port Fa0/2 has already been configured appropriately. The IP phone and PC work properly. Which switch configuration would be most appropriate for port Fa0/2 if the network administrator has the following goals?

Last Updated on October 29, 2020 by Admin

Refer to the exhibit. Port Fa0/2 has already been configured appropriately. The IP phone and PC work properly. Which switch configuration would be most appropriate for port Fa0/2 if the network administrator has the following goals?

No one is allowed to disconnect the IP phone or the PC and connect some other wired device.

If a different device is connected, port Fa0/2 is shut down.

The switch should automatically detect the MAC address of the IP phone and the PC and add those addresses to the running configuration.

• SWA(config-if)# switchport port-security
  SWA(config-if)# switchport port-security mac-address sticky
• SWA(config-if)# switchport port-security mac-address sticky
  SWA(config-if)# switchport port-security maximum 2
• SWA(config-if)# switchport port-security
  SWA(config-if)# switchport port-security maximum 2
  SWA(config-if)# switchport port-security mac-address sticky
• SWA(config-if)# switchport port-security
  SWA(config-if)# switchport port-security maximum 2
  SWA(config-if)# switchport port-security mac-address sticky
  SWA(config-if)# switchport port-security violation restrict

  Answers Explanation & Hints: The default mode for a port security violation is to shut down the port so the switchport port-security violation command is not necessary. The switchport port-security command must be entered with no additional options to enable port security for the port. Then, additional port security options can be added.

For more question and answers:

Click Here CCNA 2 SRWE v7 – Modules 10 – 13 – L2 Security and WLANs Exam Answers Full 100%