MF Wireless Technologies and Standards Quiz Online

1. Question

2 points

Which of the following statements are not correct with regards to the transmission of electromagnetic waves? (Choose 2)

The IEEE 802.16 defines the WiMax technology.
Wireless technology refers to the transmission of electromagnetic waves.
Similar to IEEE 802.15-1, the IEEE 802.15-4 standard define transmission of data over long distances.
Global System for Mobile communication is one of the standard for wired communications available in the world.
PAN is built for lower power transmission and lower data rate.

2. Question

1 points

Which statement is not correct?

Frequency is the number of occurrence of repeating event per unit time.
The higher the frequency, the higher is the absorption rate in the Earth’s atmosphere.
Frequency is measured in Hertz(Hz) or in seconds(s).
The higher the frequency, the higher is the reflection rate of the signal.

3. Question

1 points

Which of the following answers describes a frequency that is seen 1 million times per second?

1.000.000s
1MHz
10^(-6)Hz
1Hz
1KHz

4. Question

2 points

Which of the following conditions are significant problems experienced with wireless networks? (Choose 2)

Less interference
Low data transmission rate
Signal refraction
Signal reflection
Signal easy to control

5. Question

3 points

Which 802.11 standard uses the 5GHz range? (Choose 3)

802.11ac
802.11n
802.11a
802.11b
802.11g

6. Question

3 points

Which of the following statements are correct? (Choose 3)

Wireless is always half duplex because of communication environment.
High modulation technique is required for high bandwidth.
It is free to transmit in ISM (Industrial Scientific Medical) Band.
The advantage of 2.4 and 5GHz bands is that they are not very occupied.
Wireless is always full duplex because of communication environment.

7. Question

1 points

Which is a characteristic of 2.4GHz?

The space between two consecutive channels is 3 MHz.
Each channel has 22 MHz band.
The space between two consecutive, non-overlapping channels is 5 MHz.
Each channel has 5 MHz band.
There are 12 channels in the 2.4GHz band.

8. Question

3 points

Which modulation techniques are use in Wireless LANs? (Choose 3)

Wireless Technologies and Standards Quiz 005

MIMO
DSSS
OFDM
AM
FM

9. Question

3 points

Which of the following is true with regards to CSMA/CA? (Choose 3)

To avoid collisions on a wireless network, CSMA/CA is used.
The advantage of wireless network is that they can detect a collision.
The ACK mechanism use for access control is bandwidth consuming.
Collision Avoidance implies that when a device wishes to send, it must listen first.
The RTS/CTS mechanism is used to avoid collision in wireless networks.

10. Question

3 points

What advantages does Multi-User MIMO offer to wireless networks? (Choose 3)

Support data speed beyond 1 Gbps.
Eliminate collisions
Support full-duplex communications over wireless networks.
Uses the less crowded 5GHz band.

11. Question

1 points

What is the capability in a 802.11n wireless NIC that takes all the electro-mangetic waves and composes them to one high-quality wave, resulting in a throughput increase?

Wireless Technologies and Standards Quiz 002

12. Question

3 points

Whenever Joe brings his tablet into the kitchen that has a microwave oven, cordless phone and other home appliances, his internet connection is affected. Which Wireless LAN standard might his tablet be set to? (choose 3)

Wireless Technologies and Standards Quiz 003

Wireless Technologies and Standards Quiz 001

Wireless Technologies and Standards Quiz 004

802.11b
802.11g
802.11a
802.11n

Average score
Your score