Beginning Network Addressing PT Activity

Last Updated on July 15, 2015 by Admin


This is a beginning Packet Tracer 6.1 activity designed to get you familiar with working with Packet Tracer. Your goal in this Packet Tracer activity is to configure the following:

1.  Both PCs with IP addresses, subnet masks, and default gateways.
2.  Configure each switch with: a hostname, an IP address and subnet mask on the VLAN 1 interface, and bring up the VLAN 1 interface.
3.  Configure the router with: a hostname, and IP address and subnet mask on each gigabit ethernet interface, and bring up the interfaces.


Command Examples

switch> enable
switch# configure terminal
switch(config)# hostname S1
S1(config)# interface vlan 1
S1(config-if)# ip address
S1(config-if)# no shutdown

router> enable
router# configure terminal
router(config)# hostname R1
R1(config)# interface g0/1
R1(config-if)# ip address
R1(config-if)# no shutdown