A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode auto . Which command must be used on SW2 to enable this EtherChannel?

Posted on by

Last Updated on October 29, 2020 by Admin

A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode auto . Which command must be used on SW2 to enable this EtherChannel?

  • SW2(config-if-range)# channel-group 1 mode on
  • SW2(config-if-range)# channel-group 1 mode active
  • SW2(config-if-range)# channel-group 1 mode passive
  • SW2(config-if-range)# channel-group 1 mode desirable
    Answers Explanation & Hints:

    The possible combinations to establish an EtherChannel between SW1 and SW2 using LACP or PAgP are as follows:
    PAgP
    on on
    auto desirable
    desirable desirable

    LACP
    on on
    active active
    passive active

    The EtherChannel mode chosen on each side of the EtherChannel must be compatible in order to enable it.

For more question and answers:

Click Here CCNA 2 SRWE v7 – Modules 5 – 6 – Redundant Networks Exam Answers Full 100%